35 POINT MAINTENANCE SPECIFICATIONS

#1. Clean evaporator coil in place #2.  Check evaporator blower motor #3. Clean and unclog drain line #4. Check float switch operation #5. Check blower capacitor #6. Check blower run amps/ voltage #7. Log Air handlers model and serial number #8.  Add thermostat into data base
#9. Check metering device #10. Check heat strips KW #11. Check air handler electrical connections #12. Check air handler insulation #13. Replace suction line insulation 6ft #14.  Log filter size/ wash filter #15. Check duct / plenum for leakage #16. Clean condenser #17. Check dual run capacitor 
#18. Check hard start kit #19. Check contactor #20. Check compressor amps/ voltage #21. Check megaohms when possible #22. Check electrical wiring #23. Check surge protector #24. Check condenser fan amps #25. Check system refrigerant charge #26. Check subcooling/ superheat #27. Check compressor plug connection #28. Inspect dissconect box #29. Inspect attic insulation #30. Log condenser model and serial numbers #31. Check breaker wire size #32. Install return fresh air scent #33. Check air handler Delta T #34. Apply condenser corrosion protection #35. Check supply grill temps.

 

 

LIMITATION OF LIABILITY

 UNDER NO CIRCUMSTANCES, INCLUDING NEGLIGENCE, OR OTHERWISE, SHALL SUBCOOL AIR AND HEAT ITS EMPLOYEES OR AGENTS BE RESPONSIBLE OR LIABLE FOR ANY CONSEQUENTIAL DAMAGES, DIRECT OR INDIRECT INCLUDING BUT NOT LIMITED TO, DATA DAMAGE, PROFIT LOSS, LOST DATA, LOSS OF OPERATING TIME OR LOSS PRODUCTS RESULTING FROM THE BREAKDOWN OR FAILURE OF ANY EQUIPMENT OR FROM DELAYS ANY SERVICE. UNDER NO CIRCUMSTANCES SHALL SUBCOOL AIR AND HEAT BE LIABLE FOR ANY LOSS, COST, OR DAMAGE ARISING FROM ANY SOURCE, INCLUDING NEGLIGENCE, IN EXCESS OF THE PRICE PAID BY THE CUSTOMER FOR THE SERVICE.